OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
27
BT46ECO
Operation
13.3.1
Belt sander (fig.h)
The belt sand can be turned through 90°.
Undo the locknuts (23).
Rotate the belt sander (9) by 90°
upwards as far as it will go.
Tighten the locknuts (23).
13.3.2
Sanding disc (fig.i)
Undo the holding nut (4) and adjust
the table console (5) to the required
angle of tilt. The set angle can be read
off using the scale (24).
Tighten the holding nut (4) back up
again.
Loosen the locking knob (25) and set
the miter gauge (6) to the desired
position.
Retighten the locking knob (25).
13.3.3
ON/OFF (fig.j)
To switch on, push the green button („I‟).
To switch off, push the button („O‟).
Summary of Contents for BT46ECO
Page 114: ......
