OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
47
BS115 / BS128HDR
15.2.2
Adjustment of belt tension
The two screws on the motor bracket are loosened
slightly.
Loosen the lock nut and adjust the belt with the tension
screw to about 2-5mm game.
Tighten the locknut.
Tighten the screws on both sides of the engine mount.
THE TEETH OF THE SAW BLADE SHOULD THE
OVERLAPPING MATERIAL TO ALSO BE ADAPTED:
1.
The thinner / narrow the workpiece, the higher the toothing.
2.
Basic rule: it should at all times at least 3 teeth own material
15.2.3
Adjustment of the miter angle
Loosen the fastening of the holding jaw
(8)
Set the holding jaw to the desired angle.
15.2.4
Clamping the workpiece
Create the workpiece at the holding jaw and tighten it with the clamp (
9
). The clamping jaw can
be adjusted according to the crank (
11
).
15.2.5
Setting the saw band tension
Check the blade tension: Never use a thumb in the middle of the saw band light pressure
- it should be about 1mm -.
If the saw blade is not tightened correctly, you must readjust the tension with the adjustment
knob
(2)
.
15.2.6
Setting the feed
Suspension with the handle of the feed (
14
) can be tightened by turning to the right, the spring
and the feed can be reduced. Turning to the left of the feed is increased.
Summary of Contents for BS 115
Page 94: ...ERSATZTEILE SPARE PARTS HOLZMANN MASCHINEN GmbH www holzmann maschinen at 94 BS115 BS128HDR ...
Page 95: ...ERSATZTEILE SPARE PARTS HOLZMANN MASCHINEN GmbH www holzmann maschinen at 95 BS115 BS128HDR ...
Page 96: ...ERSATZTEILE SPARE PARTS HOLZMANN MASCHINEN GmbH www holzmann maschinen at 96 BS115 BS128HDR ...
Page 102: ......
