Instruction Manual: Hot Tub
41
WARNING
Burn hazard from overloading the stove!
Take care not to load the stove with too much
firewood, which can fall out when the stove door is opened. When extinguishing the
embers with water (not recommended), make sure to keep a safe distance to avoid
coming into contact with the hot steam.
WARNING
Trip hazard!
Always get in and out of the hot tub slowly and gently as surfaces, especially
those of the hot tub, may be slippery. You could use the LEDs lights (optional extra) to
improve lighting conditions if you plan to use the hot tub frequently in low lighting.
CAUTION
Hot water may escape from water inlet on stove, risk of scalding (upper pipe - see item
3 in
Figure 6
)!
Avoid direct contact with the water supply.
7.3
Bathing
The following sequence of steps is recommended by the manufacturer as means of using the
product for its intended use:
1.
Regardless of the features that have been installed on your hot tub, the manufacturer
recommends that you shower before each use and that you do not apply any skin
creams, oils or hair products, as they reduce the quality of the water and, as a result,
increase the amount of maintenance required by the hot tub
2.
Remove the optional cover from the hot tub
3.
Make sure that the hot tub is filled with water according to the specifications provided in Chapter
6.6
(e.g.:
the water level must be at least 50 mm above the top edge of the water inlet for the stove)
4.
Make sure that the pH level and the alkalinity of the water are correct.
That is why you must
adhere to the specifications provided in Chapter
6.7
5.
If the water is dirty, run either the sand filter unit or the skimmer. Never get into the
water when doing this
6.
Add 35 to 65 ml of Hot Tub Clean Care detergent for a 180 hot tub / "OPAL" and 40 to 75
ml for a 200 hot tub
7.
Fire the stove as per the instructions given in Chapter
6.8
8.
Wait until the water has reached a pleasant bathing temperature between 37 and 40 °C
9.
Step carefully into the hot tub
10.
Switch on the UV lamp to disinfect the water (Chapter
6.9.4
)
11.
Make sure to drink plenty of fluids (fluids containing electrolytes) when bathing
12.
Add wood as specified in Chapter
6.8
where necessary (usually recommended every 10 to 15 minutes)
13.
If necessary, use the optional SPA accessories as specified in chapters
6.9.1
(SPA air bubble massage),
6.9.2
(SPA hydromassage), (SPA hydro water air bubble massage) and / or
6.9.7
(LED lighting)
14.
Do not bathe for longer than necessary. If you feel unwell, stop bathing immediately
15.
After you have finished bathing, switch off all appliances
16.
Carefully step out of the hot tub
17.
If necessary, start the optional skimmer and / or the optional sand filter unit
18.
Cover the hot tub using your optional cover
19.
Empty and clean the stove as per the description provided in Chapter
8.4
20.
If you have switched on the optional skimmer and the optional sand filter unit, switch
them off again.
