Holtkamp VENUS 6600 XL, Operating Instruction

Page: 11 / 32

Holtkamp Electronics VENUS 6600XL techn. Stand 04.2016 4074_04.2016 V09.2019
- 11 -
Connection 230V Remote start (potential free)
8.5 Operating the first time
After complete installation of the VENUS can be operated the
first time by switching on the electrical circuit. As soon as elec -
tricity has been switched on, the VENUS shows on the display
for about 2 seconds information about the operating type of your
VENUS and about the used software version (e.g. Holtkamp XL
Soft X.x T-Timer Free). The device is now ready and you can
program it as you wish. To make sure that the programming has
been properly carried out, you should make a test-run. After the
test-run the counter reading should be cancelled, to achieve a
correct account. Please make sure that your adjusted main time
is appropriated to the sun bed. Do not choose the main time too
long, because of the danger of the sun bed customer. Use the
adjustment setting, to limit the maximum time and therefore limi-
ting the maximum account of buyable main time to reduce to a
minimum the danger to the customer.
8.5.1 LED operating light
With the LED operating light one can see, at a glance, the ope-
rating stand of the VENUS. During the lead time: quick blinking;
main time: permanent light; run-out time: slow blinking.

March 2003 110% disconnection
After norm EN 60335-2-27/A11 (VDE 0700 part 27)
Beginning with 01 may 2003 all our XL devices are
equipped with the disconnection recommended by the
upper mentioned directions.
EN60335-2-27 The PCB of VENUS is provided with a 110%-dis-
connection. It means, that an emergency stop timer is controlled
by a third relay on the PCB. It guarantees the switching off of
the sun bed, if the main relay is not switching off once, after the
expired time.