Holtkamp Electronics MAXI 3200 techn. stand 09.2017 4025_09.2017 V09.2019
- 16 -
12.6 Short-time button
The short-time button offers the possibility for example by using
the coin reset-button to open the washing machine door to turn
the connection appliance on for 30 seconds. After using this
short-time button the functions is not useable for 3 minutes.
Defect
Possible causes
Remedy
The display is dark
Fuse defect
Change the fuse
No operating voltage
Test the mains voltage
The display shows irregular symbols
Malfunction of the µ-processor
interrupt the mains voltage for approx.
10 seconds
The MAXI functioned, but the attached
device does not functioned.
MAXI wrongly installs
Check the connection
Attached device is defect
Check the attached device
The timer functions (prices, Times etc.)
deviate from the desired function.
Wrong programming
controls and correct programming
DIP switches stand wrongly
correct DIP switches
DIP points flashing all 5 seconds
Special error
Read point „Special errors“
DIP points flashing all the time
Not allowed function
Redress the external malfunction
Electricity installations make leave only by an electrical
specialist!
12.7 Delete entrance
The delete-entrance offers the possibility bought time or rest
time to delete with the potential free contact. You find this extra
connection on the SB frame on the inside rear wall of the casing.
12.8 Coin barrier
The coin barrier offers the possibility to block the coins, e.g. if the
supply voltage is disconnected or the MAXI is off.
If should not to be possible the insert of coins during the main
and run-out time, you must set the dip switch 1 and 4 at DIP1
(special functions) on the PCB on "ON" upward additionally to
the coin barrier.
13 Malfunctions
13.1 General errors
If your MAXI does not behave as you would like, try to help your
-
self with the following list. If you cannot repair the problem your
-
self, then the trader is, of course, there to help.
