21
ASSEMBLY AND OPERATION
incorrect assembly was activated. Disassemble and assemble the appliance properly in accordance
with this operation manual.
Juicer: Operation
• Prepare the food for juicing: separate the peel and seeds from the food, and cut into small pieces -
approximately 2.5 cm x 2.5 cm in cross section. The mass of the processing food in one cycle should not
exceed 450 g.
• Turn the speed switch clockwise to the desired level.
• Continue squeezing the juice from the food until you feel that the appliance has begun to strongly
vibrate. This means it is time to clean the centrifuge.
• Turn the speed switch counterclockwise to the «0» position. Unplug the appliance from the mains
supply.
• Insert food in small portions into the loading hole of the lid while pushing with the juicer pusher.
• Take out the mesh ring grid from the centrifuge and clean it. Clean centrifuge as well if it is clogged.
• Fit the meat grinder module on the body of the food processor so that the « »
icon on the meat grinder module matches the «open lock» icon on the body of
the food processor. Then lock the module by turning it clockwise to the full stop
(to the «closed lock» icon). You will hear a click. This means that the module is
fitted properly.
• Fit the grinding head on the body of the food processor.
Meat grinder: Assembly
• Assemble the grinding head as shown in the picture.
• Insert the grinding head into the meat grinder module (make sure that the
notches around the grinding head coincide with the protrusions on the meat
grinder module) and turn the grinding head counterclockwise. You will hear the
click of the meat grinder lock. This means that the grinding head is fitted
properly.
• Fit the feed screw on the washer included in the set and insert it into the
grinding head. Fit the cutting blade on the feed screw. The cutting blade should
be turned with cutting edges to the outside, to the plate, and then fit one of the
plates on the feed screw (aligning protrusions of the plates with recesses of the
grinding head). Then tighten the fixing ring (without over tightening it while
turning).
