Programming the Essex Keypad
Note
: If the User ID, or User Code/PIN has not been assigned, you will hear one long beep
when # is entered.
Reset Keypad to Factory Defaults--- This is not normally necessary, but can be done as follows
STEP ACTION BEEP Red LED Green LED
1
The default Master Code is “123”
.
. This can be changed to a unique code 3 - 8 digits long.
2 Enter
*3 1 2 3
#
Double Beep Slow Flash Solid
3 Enter
2
#
Double Beep Slow Flash
Slow Flash
4 Enter the desired activation time in
Seconds
followed by
#
Triple Beep Slow Flash
Solid
5 Enter
* *
to exit
6 Example:
2 # 10 #
* *
(10 second activation time)
Setting Main Relay Opening Time
STEP ACTION BEEP Red LED
Green LED
1 Remove power
2 Jumper the “CONFIG” pins on the rear of the keypad
3 Apply 12 VDC power to red and black wires ONLY Quadruple Beep Flash Solid
5 Enter
0 0 9 9
#
Double Beep Flash
3 Sec Flash
6 WAIT about 4 seconds Quadruple Beep Flash Solid
7 Enter
9 9
#
Triple Beep Flash
Solid
8 Remove power
9 Remove “CONFIG” jumper
10 Reapply power
Page 8
TYPE 6.2.0.7-RF
