4. OPTIONS OR ACCESSORIES
The following options or accessories may be present on your
installation.
4.1 Visor Installation and Maintenance.
When
installed, the visor limits the vertical spread of emitted light.
4.1.1
Attach the clips to the shield, one in the center and one on
each corner at approximately the location of the holes. The shield
goes into the narrow side of the clip. See Figure 3.
4.1.2
Fasten the shield with the clips to the door assembly. A
small screwdriver can be used to spread the leg of clips to start
them over the cast rib on the door.
NOTE
Three 3/16" diameter holes in shield can be used as a template if
the installer chooses to drill holes through the casting rib and fasten
the shield to the door with screws (not included). Screws are
recommended in high wind and rough service areas.
4.1.3
Clean accumulated dust and dirt from visor when relamping.
4.2 Wire Guard Installation and Maintenance.
When
installed, the wire guard helps protect the tempered glass lens from
damage.
4.2.1
Loosen the captive door screws. See Figure 4.
4.2.2
Slide the mounting loops in the wire guard over all four
screws.
4.2.3
Tighten captive door screws to 55 in. lbs. torque. This is
required for watertight door seal.
5. Limited Warranty and Limitation of Liability
The Holophane limited warranty and limitation of liability is published
in the "Terms and Conditions" section of the current Holophane
buyer's guide, and is available from your local Holophane sales
representative.
Figure 3
GR423
Figure 4
GR424
Acuity Lighting Group, Inc.
214 Oakwood Ave., Newark, OH 43055
IM-63-C 7/02
2002 Acuity Lighting Group Inc.
Visit our web site at www.holophane.com
Printed in USA
®