IM-274-E
4
•
Brush off loose dirt and debris. The optical
assembly may be cleaned with water and
detergent to return it to maximum optical
performance. Dry the assembly with a clean
cloth.
•
Check the exterior of the housing for evidence of
damage or potentially hazardous conditions.
•
Remove the lamp when cool and replace with the
exact type shown on the luminaire ballast
housing.
•
Restore power to the luminaire, the lamp should
strike within 1-2 minutes.
2.4.2 Ballast
Replacement
•
There are no user serviceable parts or fuses on
the ballast
•
Disconnect electrical power to the fixture.
REMOVE THE FIXTURE TO A HORIZONTAL WORK
SURFACE BEFORE ATTEMPTING TO REMOVE ANY
SCREWS THAT SECURE THE HOUSING AND OPTIC
ASSEMBLY TOGETHER. FAILURE TO DO SO MAY
RESULT IN INJURY OR DEATH OR SIGNIFICANT
PROPERTY DAMAGE.
•
To separate the electrical assembly from the
optic assembly, use 3/8 socket driver to unscrew
two screws from the electrical housing assembly.
For standard construction see
Figure 5.
For EA option construction see
Figure 7.
•
Carefully disconnect the leads between the optic
assembly and electrical assembly
•
Disconnect all leads connected to the ballast
•
Loosen four screws holding the ballast to the
housing
•
To re-install the ballast to the unit reverse
previous steps and make sure the ballast is
installed tightly to the wall.
2.4.3
Optical Component Replacement
•
Disconnect electrical power to the fixture.
REMOVE THE FIXTURE TO A HORIZONTAL WORK
SURFACE BEFORE ATTEMPTING TO REMOVE ANY
SCREWS THAT SECURE THE HOUSING AND OPTIC
ASSEMBLY TOGETHER. FAILURE TO DO SO MAY
RESULT IN INJURY OR DEATH OR SIGNIFICANT
PROPERTY DAMAGE.
•
Check, the exterior of the housing, arched rods,
socket, top and bottom rings for evidence of
damaged or potentially hazardous conditions.
•
To separate the optic from the electrical
assembly, use 3/8 socket driver to unscrew three
screws from the bottom ring, see
Figure 6.
•
Remove damaged optic from the assembly.
•
Position the replacement optic into bottom ring.
•
Set the electrical assembly on the top of the
replacement optic.
•
Install three arched rod ends to top ring,
•
Install three arched rods to bottom ring.
•
Install screws (Apply torque 55-65 inch pound)
onto bottom ring nuts and evenly tighten.
•
Install lamp of proper wattage as specified on
luminiare.
3
Operation of the Electronic Ballast
3.1 Luminaire Operation
•
Lamp Starting
When the is unit powered, the lamp should strike
within 1-2 minutes.
3.2 Dimming
The Enduratron luminaires can be dimmed to
50% power with the application of a 0-10Vdc
dimming signal applied to the dimming terminals
on the top of the luminaire. If no dimming signal
is connected to the dimming terminals, the
luminaires will operate continuously at 100%
power.
The dimming operation of electronic ballast is
suspended for the first 20 minutes of operation of
the luminaire. The lamp will operate at 100%
power during this period. This delay is required to
stabilize the lamp thermally to permit good color
control and lamp stability thru life as prescribed
by the lamp manufactures.
4
Limited Warranty and Limitation of Liability
The Holophane limited warranty and limitation of
liability published in the Holophane Price
Schedules and is available from your local
Holophane sales representative.