Chapter 3: System Operation
16
Cenova™ Image Analytics Server 2.4 User Guide – MAN-03998 Rev 001
4
Click
System Control
to display the following screen:
5
Click
Shutdown
. The server prompts ‘Are you sure…?’ Click
OK
to switch the server
off.
m
Note:
Physical
access to the server is required to restore power from a shutdown. If the
server is in a remote location, use
Restart
.
3.3.2.
Starting Up the Server
If the server has been powered off, you can switch it back on by pressing the power
switch on the front of the computer. (An indicator light indicates whether the server is
on or off.) The Cenova software starts up automatically, and the server should be ready
for use within 3–5 minutes.
3.3.3.
Restarting the Server
You might need to restart the Cenova server if results are not transferring. Often,
restarting the server clears any errors. In some cases, your service representative will
ask you to restart the server.
To restart the server:
1
Using a computer that is on the same network as the Cenova server, open a web
browser.
2
Type the IP address for the Cenova server in the address box and press
[Enter]
. You do
not need to type ‘http’ or anything other than the IP address.
3
At the log-in screen, enter the user name (‘Administrator’) and password. The About
screen should appear as shown in the previous procedure.
4
On the About screen, click
System Control
.
5
From the System Control screen, click
Restart
. The server prompts ‘Are you sure…?’
Click the Restart button once more. The server should shut down and then restart
automatically. The server should be ready for use within about 5 minutes.
m
Note:
To continue using the server, refresh the browser by repeating steps
1
–
3
.