Holms Dustbuster
© HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 160429.
15
Side brush
Holms Dustbuster can be fitted with a side brush for more
efficient sweeping up against kerbs, etc. It can be fitted
on the right or left side. The brush is automatically
extended/retracted when started/stopped.
Connection of side brush
See “Connection" in the Driver instruction Radio control.
Setting the side brush
The basic brushing pattern setting on the side brush is
made using the round holes on the bracket
The side brush is possible to adjust laterally and
longitudinally (accessory), see figure 6.
If a brushing pattern other than the preset pattern is
required, see figure 8, this can be adjusted by moving the
screws to the oval holes, angling the brush and tightening
the screws, see figure 6
The brush’s contact pressure against the ground can be
adjusted by loosening the lower knob, see figure 7, turn
the upper knob clockwise to increase the ground pressure
or anticlockwise to reduce the ground pressure. After
adjusting, lock the lower knob again
By allowing the side brush to rotate for a while against
the ground and then raising it, the brushing pattern can be
studied. Only the forward, outer part should touch the
ground, see figure 8.
Operation
See "Pick-up sweeper" in the Driver instruction Radio
control.
Always turn the side brush and sweeper roller off
before making any adjustments.
6. Adjusting laterally and
longitudinally
7. Adjusting the contact
pressure
-
+
8.Brushing pattern