Holms DUO
18
© HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 150603.
Maintenance
After operation
•
Wash the sweeper. This will increase its service life
and make it easier to detect any leakage or other
faults.
•
Inspect the machine and make sure that the hoses,
rubber housings and the machine body are not
damaged. Also check for any oil leakage.
•
Top up the lubrication points, see figure 15 and
figure 16.
Brush replacement
Tools
•
ring spanner 13 mm
Removing the roller brush sweeper
1. Release the scoop (extra accessory)
2. Remove the lifting stops on both the right and left
side. See A in figure 17.
3. Release the rear mount on the slewing bracket on the
right-hand side. See B in figure 17.
Please note that only the screws are released from the
outside and that the actual slewing arm can remain on
its clamp plate, see figure 18.
4. Carefully lift up the machine to allow the motor to be
pulled out from the side. See figure 18.
5. Turn out the brush.
Make sure that the brush has stopped moving
before maintenance.
If the machine is lifted too high before the roller
brush has been removed from the motor unit, the
roller may become caught in the hydraulic hoses
and there is a risk that they may be damaged.
15.Lubrication point
16.Lubrication points
17.Removing the water tank, lifting
stops and slewing brackets
A
B
A
A
A
18.Removing the motor
Clamp plate for slewing brackets
Summary of Contents for DUO 1.50
Page 2: ......
