EN
PCU50
916.400.096_003
49
7.7
The motor operates at slow speed during or after the tool has been put into
water
/i
8
Maintenance
8.1
General
Proper preventive maintenance of the equipment preserves the operational safety and extends the life
of the equipment. For malfunctions or repair, always specify the model and serial number of the
equipment.
8.2
Dangerous substances
8.3
Maintenance materials
/i
Contact the Holmatro dealer for information on spare parts.
The tightening torque of the centre bolt is
incorrect.
Tighten the bolt to 50 Nm.
Possible cause
Solution
The electrical circuit has a temporary fault.
The tool operates in safe mode.
Clean the tool fully. Refer to 6.4.4.
CAUTION
When performing maintenance activities, always comply with the relevant safety regulations.
Wear the prescribed personal protection equipment.
CAUTION
Used or leaked fluids, and any other products consumed during the activities,
must be collected and disposed of in an environmentally responsible way.
Application
Type of maintenance material
Amount
Steel parts
WD-40 preservative oil
As required
Hinge pins
Teflon lubricating oil
As required
Long-term preservation
Tectyl ML from Valvoline
As required
Possible cause
Solution
Summary of Contents for PCU50
Page 3: ...PCU50 916 400 096_003 3 Fig 1 Fig 2 ...
Page 4: ...4 916 400 096_003 PCU50 Fig 3 Fig 4 Fig 5 ...
Page 173: ...PCU50 916 400 096_003 173 i Fig 6 Fig 7 ...
Page 174: ...174 916 400 096_003 PCU50 Fig 8 Fig 9 Fig 10 Fig 11 90 C A A B ...
