Holmatro CBCH, Manual, Page: 5 / 16

916.400.341_001.docx 5
Notice. To have the charge level displayed on the battery pack: remove the battery pack from the charger and press
the button on the battery pack.
B. Conservation charge
When the charging process has finished the battery charger switches to conservation mode automatically. The battery
pack can remain in the battery charger and is therefore always ready to use. The operating display lights up
continuously.
8. Errors
Warning indicator (4) Status
C Temperature too high / too low
D Battery pack defective
C. Warning indicator (4) lights up continuously
The temperature is too high or too low. The battery pack is not charged. When the temperature is between 0°C and
50°C (32°F to 122°F) the charging process will start automatically.
D. Warning indicator (4) blinks
The battery pack is defective. Remove the battery pack from the charger.
The battery pack is not pushed completely to the end of the sliding seat.
9. Repairs
Repairs to the charger must only be done by a qualified electrician. If the mains cable is damaged it must be replaced
by the manufacturer. Contact your local Holmatro dealer.
10. Environmental protection
Do not dispose the battery charger into the house and residual waste removal.
According directive 2012/19/EU used power tools must be collected separately and recycled in an
environmentally-friendly way.
11. Charging specifications
Voltage range of the battery pack U 18 V
Battery pack capacity C 2.0 Ah
charging current Ic 4.0A
charging time t 30 min
Real charging times may deviate from the specifications. This depends on:
•
The residual capacity of the battery pack
•
The temperature of the battery pack.
•
The age of the battery pack
12. EC DECLARATION OF CONFORMITY OF THE EQUIPMENT
Manufacturer: Holmatro Rescue Equipment B.V.
Address: Zalmweg 30, 4941 VX Raamsdonksveer, Netherlands
Declares that the following products:
Product type: Li-ion battery charger
Models:
CBCH1, part no. 151.002.112 CBCH5, part no. 151.002.113
CBCH2, part no. 159.000.212 CBCH7, part no. 151.002.114
meets the requirements of:
Directives: 2014/30EU, 2014/35/EU, 2011/65/EU
Standards: EN 60335-1, EN 60335-2-29, EN IEC 63000: 2018
Netherlands, Raamsdonksveer, 31.03.2022
Ing. H. W. M. Hermans MBA