CLEANING continued
MONTHLY
1. Turn power switch to the OFF position. Disconnect unit from power source and
allow to cool.
2. Perform daily & weekly cleaning procedures.
3. Working from the power supply side of the oven, locate the side panel, remove two
screws holding panel in place and remove panel. Drive chain is now exposed.
4. Check drive chain tension.
a. When properly adjusted, chain will
have about 1/8" play but will not
sag.
See Chain Tension Illustration on
page 12.
b. To adjust drive chain tension,
locate the drive motor mounting
screws (see illustration). Loosen
screws holding drive motor in
place and slide drive motor
forward or backward to adjust
chain tension. With proper chain
tension, retighten motor screws.
c. Following the procedures on page
12, Lubricate drive chain and
sprocket teeth with a high temp lubricant part no.
1P-Z8914.
5. Clean air intake on the side of the unit by vacuuming any dust and debris built up on the fan
grill.
6. Remove screws holding the control side panels in place (as shown below). Carefully lift panel
up and out. Vacuum any dust and debris from inside the unit, being sure to clean the fan
blades and inside of unit, repeat opposite side.
7. Replace all panels when completed.
CHECK NO WIRES GET PINCHED AS THE PANELS
ARE REPLACED. ALSO, CHECK ANY WIRES AROUND THE MOTOR TO MAKE SURE
THEY DO NOT INTERFERE WITH THE SPROCKETS.
8. For exterior portions of unit that are heavily soiled, an abrasive pad may be used for cleaning.
Be sure to pass the pad in the direction of the grain in the metal to maintain the surface's finish.
Lightly soiled surfaces may be cleaned with a damp cloth and mild cleaner.
IL1156
DRIVE MOTOR
MOUNTING SCREWS
DRIVEN SPROCKET
DRIVE SPROCKET
UNLOAD TRAY
IL1155
CHAIN
9. Reconnect unit to power
supply and test for proper
operation.
IF ASSISTANCE
IS REQUIRED, CALL THE
STAR SERVICE HELP DESK
AT 1-800-807-9054.
