FIG. 1:
Black Knob with threaded
rod attached and pivoting spacer
block.
Tools required: 2 adjustable wrenches or two ¾” wrenches (open, box or socket).
1. The rack is easily assembled on your workbench or any flat surface. To assemble the rack, lay
the upright beam face down on the bench (Hollywood sticker facing down). Place the insert
tube’s bracket onto the end of the upright beam so that the insert tube is pointing up.
2. Place a washer on the end of the through bolt, then insert the bolt through the lower hole of this
bracket, and pass it through the lower hole of the upright beam. We keep our hole tolerances
fairly tight, so you may have to wiggle it through. Once the bolt is protruding through the other
side of the bracket, install the other washer and nut. Tighten the nut securely using your
adjustable wrenches or ¾” wrenches. Insert the lynch pin through the upper hole, then install the
lynch pin clip.
3. Insert the knob through the spacer as shown in Fig. 1 (the knob should be against the flat end of
the spacer block). Align the threaded hole in the vertical cylinder (fig. 4) so that it faces out. You
can rotate the vertical cylinder using a coin or flat blade screwdriver in the slot at the top of the
vertical cylinder. Insert the knob through the support arm, and thread the knob into vertical
cylinder inside the main top horizontal tube. Repeat for the Driver’s side arm.
Fig. 3 Insert tube (1-
1/4” shown)
Fig. 4
Vertical Cylinder
FIG. 5
Driver’s Side Support Arm
FIG. 6
Passenger’s Side Support Arm
FIG. 2:
Clockwise from upper left,
hitch pin clip, star washer, flat
washer and threaded hitch pin.