Installa on & Opera on
8
IR BLASTER (TX)
To control the source: Plug IR Blaster into IR TX port of transmi er unit; place blaster in front of the IR eye of
the source. To control the display: Plug IR Blaster into IR TX port of receiver unit; place blaster in front of the
IR eye of the display.
Note: Placement of the IR Blaster is important and can result in the IR system not working if improperly placed.
First, locate the IR eye or window on the source
If placing the IR blaster right on the front panel of the source, do not s ck right on top of the IR eye or
IR window. The IR signal cannot travel through the double-sided tape on the Blaster. Instead place the blaster
on either side, or on the top or bo om of the IR eye or window, with the p of the blaster facing the IR eye or
window. See below for illustra on of where IR signal shoots from on IR Blaster:
IR
window/eye
INCORRECT IR BLASTER PLACEMENT
IR
window/eye
CORRECT IR BLASTER PLACEMENT
×
IR RECEIVER (RX)
To control the source: Plug IR Receiver into IR RX port of receiver unit; place receiver at or near display.
To control the display: Plug IR Receiver into IR RX port of transmi er unit; place receiver in posi on where it
is able to receive remote signals.
