Hollis ENVIRO-PRO Large, Owner'S Manual, Page: 30 / 48

30
FINAL CONFIGURATION
Your Katana Sidemount Harness comes pre-assembled which makes final configuration much easier.
The last step is the adjustment of the harness is to ensure proper fit when donning the harness. First
tighten the waist strap. This will help the following steps pull the harness tight against the body. Next,
secure the sternum strap to its appropriate length.
NOTE Tighten the sternum strap just enough to keep the shoulder straps straight over the
shoulder. DO NOT over-tighten which causes the straps to pull towards middle.
Finally, adjust the shoulder webbing. This should provide a firm and comfortable fit. You may need to
give the sternum strap one final tug once complete.
The wing retention system or “bungee” is used to keep the wing streamlined when not fully inflated. It
pulls the excess material in while still allowing full inflation. The bungee can be trimmed to the desired
length. However use caution as you may need this additional bungee length at a later date. Once
trimmed it can not be replaced without replacing the whole strap.
NOTE Over-tightening will reduce the amount of lift in the wing.
Although preparation will take a small time investment, once you have completed the configuration
steps (rigging the tanks, attaching the cylinders, and adjusting the harness properly) your in water
profile should look something like below. Trim is horizontal and streamlined.
NOTE Cam band more towards the rear or bottom of tank = Feet down / Cam band more
towards the front or top of tank = head down