44
33.1.1 Outputs
The OUTPUT screen allows for the Fan #1 and Fan #2 ON and OFF temperatures to be adjusted. The ON temp needs to always be a
higher value than the OFF temp. Use a difference of at least 5 degrees so they aren’t cycling excessively. In Terminator Kits these are
ground outputs that should be wired to trigger the fan relays. NEVER wire them directly to the fans! The AC Disable value is a TPS value
above which a 12 volt output is sent out to deactivate the air conditioning compressor at wide open throttle.
Figure 110
Figure 111
Figure 112
33.1.2 Engine Setup
These parameters should all be properly pre-set when you went through the Wizard process. If you change something on your engine, or
run a different system fuel pressure or injector size, they can be edited here
Figure 113
Fuel Injector Flow:
Adjust fuel flow injector ratings to match what is installed on the engine
Actual System Fuel Pressure:
Enter the actual fuel system pressure for accurate fuel map & logging data.
Wide Band O2 Sensor Type:
Selects the type of wide band oxygen sensor used. If the software selection does not match the sensor
being used damage to the WBO2 sensor will occur.
Summary of Contents for 550-407
Page 52: ...52 Figure 135 Figure 136...
Page 53: ...53 Figure 137 Figure 138...