15
XL-FW10054UM-en-US Rev C· 2018-01-29 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Figure 34
Figure 33
Maintenance Procedures
8. Verify the proper adjustment by locking
and unlocking fifth wheel several time
with lock tester. Verify that there is at
least 1/16" of forward and backward
play in the lock by sliding a 1/16" drill
bit between the front edge of the kingpin
on the lock tester and the front lock
(radius) of the fifth wheel
(Figure 33)
.
NOTE:
A minimum of 1/16" free play
is critical to proper operation of
the fifth wheel.
If there is NOT 1/16" minimum freeplay
in the lock, the fifth wheel lock adjustment
pin must be rotated counterclockwise
to the next lower position. Reverify that
1/16" minimum play exists using 1/16"
drill bit as described above. Check that
the fifth wheel is properly locked.
9. Rotate lock adjustment tool from side-
to-side to ensure that the lock is not
over tightened. The lock should not grip
the kingpin and the lock tester should
rotate freely.
14. Pocket Insert Inspection
Replace pocket inserts if:
The free vertical movement of top plate
on the bracket is 1/2" or greater, without
compressing rubber bushings
(Figure 34)
.
The bracket pads or shoes are severely
chipped, cracked or gouged.
DRILL BIT
REPLACE
IF 1/16"
OR LESS
1/2" MAX. (MEASURED AT EAR)
PUSH DOWN
Summary of Contents for FWS1 Series
Page 2: ......
