C 9700 ... C 9.88 H
Operating Instructions
92
145 052
Operating the Implements
Adjusting Catch Hook and Catch Hook Bar
You can adjust the catch hook laterally and longitudinally.
-
Measure the stand-off of the pins on your implement.
-
Disengage the clamping screws (6) on both sides.
-
Slide the catch hook laterally until the required distance
is reached.
-
Retighten the clamping screws.
-
Equipment of category II can be attached with the catch
hook (5) directly;
-
For equipment of category I install the reducing
sleeves on the left and right.
Adjusting the Length of the Catch Hook Bar
-
Disengage 2 locknuts and clamping screws (inside and
at bottom) on the lower link (2).
-
Pull the linch pin out of the pin (1) and remove the pin.
-
You can put the catch hook bar (3) in one of 3 positions.
-
Insert the pin (1) in the hole and secure with the linch
pin.
-
Retighten the locknuts and clamping screws.
DANGER
Make sure no-one is standing between the
tractor and implement.
-
Drive the tractor to the implement to be picked up.
1 Pin with linch pin
4 Quick attach
2 Lower link support
5 Catch hook
3 Catch hook bar
6 Clamping screw
(adjustable) with 3 positions
-
Steer the catch hooks (5) below the attaching pin of the
implement.
-
Raise the front lift until the quick attach (4) closes and
engages.
2
3
4
6
1
5
Bild_53
Hole
Position
Used for
1st hole
Front
Category I and II
2nd hole
Centre
Category I
3rd hole
Rear
Optional attachments
