HOKUBEMA PANHANS 546|100, Operating Manual

Page: 38 / 55

BA_PH_546-100_EN_06-22.docx
38
11.2 Activating the Controller
The controller activates automatically when the machine is switched on. The main menu appears.
➔
Switch ON the machine
Figure 34: Screen at start-up (booting) Figure 35: Screen “ ready for use ”
•
When booting, the main menu initially appears in German language, graphically unclear, blurred and with a
red
→
As soon as the main menu appears clear and sharp, the position controller and the machine are
ready for operation (see
 
Figure 35).
•
Press the “ Machine ” button for normal positioning mode (see

11.3).
•
To calibrate the table height, press the button “ Setup ” (procedure see

11.5).
Symbol
If the "Info" icon still appears in red after booting, then tap on the icon to open the "Info"
menu and explore the cause of the problem. For more details refer to

11.3 und

11.7.
11.3 Operating States & Language ("Info" Menu)
By tapping the symbol resp. you can access the “ Info ” menu. Various operating states, the machine and
version number, the year of manufacture and various messages are displayed here. In addition, the menu lan-
guage (German, English or French) for the control system can be set here.
Figure 36: Info menu with status messages Figure 37: Language menu
•
Status messages (example

Figure 36): Here the voltages required for operation are missing for the thick-
nesser, the pull-out (automatic outfeed) as well as for the surface planing table. Operation is only possible af-
ter the faults have been remedied. If the end limit symbol is active, you must first move out of the end limit
range so that the message becomes inactive and can be positioned with the control unit (see

11.4.1).
•
Detailed information about all error and warning messages can be found in the section

11.7.
•
Tapping the flag symbol at the bottom left opens the language menu (see

Figure 37).
The desired menu language can be chosen here.
i
i
i i