T24
To Crank Cutout contact (Normally Open). From external Speed Sensing Relay
TFQ-1
.
T25
Positive ( + ) supply output when Fail to Start relay (
ASR)
energized.
T26
Positive ( + ) supply output
to Alarm Bell.
T27
Flashing (On - Off) positive ( + ) supply output. For use, if required.
T28
To Lamp Test push-button (Normally Open).
T29
Positive ( + ) supply output when Oil Pressure Delay timer Up. For use if additional contacts are
required.
T30
Negative ( - ) supply output. Internally connected to T17.
T31
Negative ( - ) supply output. Internally connected to T17.
T32
Negative ( - ) supply output. Internally connected to T17.
TERMINALS L1 TO L8 - LAMP OUTPUTS
L1
To indicator lamp No. 1 (corresponding to
S1
).
L2
To indicator lamp No. 2 (corresponding to
S2
).
L3
To indicator lamp No. 3 (corresponding to
S3
).
L4
To indicator lamp No. 4 (corresponding to
S4
).
L5
To indicator lamp No. 5 (corresponding to
S5
).
L6
To indicator lamp No. 6 (corresponding to
S6
).
L7
To indicator lamp No. 7 (corresponding to
S7
).
L8
To indicator lamp No. 8 (corresponding to
S8
).
TERMINALS S1 TO S8 - FAULT SIGNAL INPUTS
S1
To volt-free fault signal contacts (Normally Open) No. 1. Close to +ve or -ve to trigger.
S2
To volt-free fault signal contacts (Normally Open) No. 2. Close to +ve or -ve to trigger.
S3
To volt-free fault signal contacts (Normally Open) No. 3. Close to +ve or -ve to trigger.
S4
To volt-free fault signal contacts (Normally Open) No. 4. Close to +ve or -ve to trigger.
S5
To volt-free fault signal contacts (Normally Open) No. 5. Close to +ve or -ve to trigger.
Page 9
HOKKIM
giving you control
Control & Protection Relays
Summary of Contents for HAMF-4
