HOKKIM HAMF-4, Manual, Page: 8 / 15

TERMINALS T01 TO T32 - MAIN CONTROLS
T01
Positive supply (+12Vdc or +24Vdc) input direct from fuse or circuit breaker.
T02 Positive supply output protected by 10A fuse on base PCB. For use, if required.
T03 To Emergency Stop push-button (Normally Close).
T04 To Emergency Stop push-button (Normally Close).
T05 To Common terminal of Auto - Manual - Test selector switch.
T06 To Auto terminal of Auto - Manual - Test selector switch.
T07 To Manual terminal of Auto - Manual - Test selector switch.
T08 To Test terminal of Auto - Manual - Test selector switch.
T09 To Manual Start push-button (Normally Open).
T10 To Manual Start push-button (Normally Open).
T11 To Mains Fail contact (selectable Normally Open or Normally Close).
T12 To Mains Fail contact (selectable Normally Open or Normally Close).
T13 To Bell Cancel push-button (Normally Open).
T14 To Bell Cancel push-button (Normally Open).
T15 To Alarm Reset push-button (Normally Close).
T16 To Alarm Reset push-button (Normally Close).
T17 Negative ( - ) supply input from battery.
T18 Negative ( - ) supply output. Internally connected to T17.
T19 Positive ( + ) supply output when Fault Monitor Relay trips. For use as master alarm or in
Building Automation System if required.
T20 Positive ( + ) supply output to external Energized Stop relay.
T21 Positive ( + ) supply output to external Fuel Solenoid Relay (Energized Run relay).
T22 Positive ( + ) supply output to external Start relay (Crank relay).
T23 To Generator Run contact (Normally Open). From external 240VAC AFR relay.
Page 8
HOKKIM
giving you control
Control & Protection Relays