Step #2:
With the cabinet removed from bike undo the 4 screws that hold the
factory speaker to the cabinet. Carefully take off each speaker wire by
disconnecting one at a time. Take a Hogtunes 362F-RM (front) speaker and
attach the factory speaker wires noting they will only go on one way ,and that
the built in barbs will secure the factory connectors. Using the factory screws,
attach the Hogtunes speaker to the cabinet noting that there is a locator
“peg” on the cabinet and a hole in the speaker’s frame which need to line up.
The factory speaker grill can be left in or replaced with the supplied metal
mesh grill using the 3 factory screws on the inside of the fairing. On the
Hogtunes grill, you will see two holes and one “keyhole” where the screws go
through and into the fairing. The keyhole in the Hogtunes grill needs to be
oriented so it is closest to the radio on each side for proper fitment. Please
note that the Hogtunes mesh grills will allow the speakers to play louder than
the factory cloth covered grills!
With the grills in place and the speaker
properly attached to the speaker cabinet, the cabinet can be re-installed.
Repeat Step #2 for the second cabinet. Don’t re-attach the speaker connectors
on the cabinets back to the bike yet. Make sure to plug the power cable back
into the power port/cigarette lighter assembly on the brake side as well as
reattaching the wire harnesses to the cabinets with the factory “Christmas
Tree” fasteners. If your bike has the CB module, make sure to re-install the
antenna cable and main harness.
3
Figure 1.1 Side View of
Brake side cabinet
Figure 1.2 Back View of
Brake side cabinet
Technical Specifications:
362F-RM Front and 362R-RM Rear Speakers
Power Handling: 125 RMS-200 Peak
Frequency Response: 55hz-25Khz
Sensitivity:
92 db 1watt/1meter
Nom. Impedance :
2 Ohms
NCA 450-RM Amplifier
Amp’s RMS Power at 2Ω: 50 Watts x 4 Channels
Frequency Response:
40hz - 25khz
Fuse at Amp:
30 amp
Topology:
Class A/B
10
