Thank-you for choosing the Hogtunes Limited-RM Kit. Since positive word of mouth
is the best way to grow our business, we want your new system to work as well as it
was designed to. If you have any questions or concerns, we are here to help. Email
[email protected], or call us during regular business hours (EST) at (705)-719-6361.
If you still need help, please consider a professional installation by your dealer.
Getting Started:
Step #1: Remove the seat, and both wires (+ and -) from the battery.
Step #2: Remove the outer fairing/headlamp assembly. Refer to a service manual if
you need help with this. Note: A towel on the front fender can help prevent
scratches or “dings” from dropped tools or fasteners etc. Colorful expletives and
flying wrenches will most likely also be kept to a minimum.
Rear Speakers:
Step #1: Remove the factory rear speaker grills by undoing the 4 screws on the front
of the grills. Carefully lift up on each speaker and take the 2 wires off by pulling one
at a time from the stock speaker. Remove the speakers.
Step #2: Locate the
Hogtunes 362R-RM (rear speakers) that came in the kit. The
female OE connectors mate with the male connectors on each speaker and only go
on one way. Once you are confident the factory wires are correctly attached to the
new speakers, set them in place, install the grills that came with the kit and secure
the speaker by reinstalling the 4 screws per grill. It’s a good idea to get all 4 grill
screws “started” and then get each one snug. Gradually tighten each one down
making sure all 4 screws holding the grill down are snug but secure!
Front Speakers:
Step #1: On the brake side speaker cabinet, carefully remove the cable going into the
power port/cigarette lighter assembly. If your bike has the CB module (mounted
“sideways” on the clutch side cabinet) undo the antenna cable and main harness.
The CB Module will stay attached to the clutch side cabinet when removed. Undo the
speaker wire plugs going into each cabinet (pink & pink with black stripe wires).
Smaller harnesses are attached to the cabinets with “Christmas tree” fasteners, and
are easy to pull off. Figure 1.1 and 1.2 (on next page) have arrows that point to the
factory fasteners that will be removed to allow the cabinets to come out of the bike.
Although the brake side is shown on next page, fastener locations are common for
both brake and clutch side cabinets.
This Kit Has The Amplifier Power the Front And Lower Speakers While The
Radios Built In Amplifier Powers the Rear Speakers.
This System is Designed To Work With Factory Radio Software.
NO DEALER RADIO SOFTWARE “REFLASHES” ARE REQUIRED!
2
NOTE: We STRONGLY suggest completing the front speaker installation
on one side of the bike and then moving to other side!
Harley-Davidson, Electra Glide, Road Glide, Street Glide, Ultra Classic, Tri Glide
CVO, Screamin Eagle and Tour-Pak® are Trademarks, and/or Registered
Trademarks of Harley-Davidson, Inc., Milwaukee, Wisconsin, USA, and if
Used or Implied are for Reference Only. There is No Affiliation
Between Harley-Davidson, Inc., and Hogtunes Inc.
11
