3
GETTING STARTED
Step #1: Remove the seat, and both wires (+ and -) from the battery.
Step #2: Remove the outer fairing/headlamp assembly. Refer to a service manual
if you need help with this. Note: A towel on the front fender can help
prevent scratches or “dings” from dropped tools or fasteners etc.
Expletives will also be kept to a minimum!
Step #3: Take the 2 wires off each front speaker by gently pulling one at a time.
Undo the screws that attach each speaker/grill assembly to the inner
fairing and remove. Pull the stock speaker out of each grill assembly.
Step #4: “Clip” the Hogtunes speaker into each grill assembly. Position your new
speaker/grill assembly onto the inner fairing, and re-attach each one
using the OE screws. Although a hand driven tool is suggested for this,
the screws need to be tight enough so the speaker/grill assembly will not
rattle during riding and potentially cause a false warranty claim.
Diagram 1.1
Standard, Street Glide, EG Classic.
No CB/XM Module Present
Diagram 1.2
Ultra Classic. Shown mounted
on top of CB Module
The amplifier gets mounted to the top of the factory radio using the supplied “hook
and loop” adhesive, and must sit so you can read the text on top of the ampli-
fier as in diagram 1.1. The amplifier needs to mount as far back on the radio as
possible so the fairing can go back on. The minimum distance from the back of
the radio to the most forward edge of the amplifier is 5/8” (15mm). On pre-2006
model bikes, it is a tight fit--but will go. 2006+ (Advanced Audio) radios have a
“bump” on top of the radio that runs from front to back down the center of the
radio. Cut the adhesive in half and apply each piece on either side of this bump.
The amp will then mount flush. Most adhesives work best at room temperature or
higher. Note: 2006 and newer Ultras have the CB module on top of the radio.
The amp will adhere on top of the CB module so it is “half on/half off this module
as shown in Diagram 1.2. The supplied adhesive is plenty strong for this! The amp
can adhere on top of CB and XM modules without issue.
4
AMPLIFIER WIRING DIAGRAM
Brake-side factory
speaker wire plugs into
green/black on amp
Brown/Black
wire plugs
into clutch-
side speaker
Blue/Black
wire plugs
into Brake
side speaker
Clutch-side factory
speaker wire plugs into
yellow/black on amp
Orange wire goes
to center pin on
cigarette lighter
Power and
ground DIRECT
to battery
Optional HF-1
Tweeter Pod
