4
Adres producenta/ Adresse des Herstellers/ Manufacturer’s Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków
The heat gun is supplied complete and does not require installation. The set also includes four additional nozzles.
WORKPLACE
To ensure safety at work, adequate lighting must be provided and the workplace must be kept clean. Do not use the device in an
environment with an increased risk of explosion, or in an environment of flammable liquids, gases or vapours. Use appropriate perso-
nal protective equipment during work and avoid work in a state of fatigue. Ensure that the workplace is adequately ventilated to prevent
the inhalation of harmful fumes generated during work.
DEVICE USAGE
Before starting work, make sure that the unit is free from defects and faults, that the power cord is not damaged or interrupted. If any
malfunction is detected, do not continue working and return the unit to an authorized service center. Make sure that the plug of the
electric cable fits into the mains socket. Avoid contact between the power cable and heat, oils, sharp edges and moving parts. Damage
to the power cord increases the risk of electric shock. Use the right tool for the job and avoid overloading it. Before starting work, the
workstation must be properly prepared. Then make sure that the heat gun switch is in position „0”. Plug into an electrical outlet while
holding the device by the handle. Direct the heat gun towards the heated surface and start it by switching the switch to one of the two
operating modes, with the parameters described in the table above, as required. Thanks to the disc at the back of the blade body it is
possible to adjust the temperature of the air stream in eight stages. The smallest permissible distance between the heat gun nozzle
and the heated surface must not be less than 25mm. Before changing accessories or storing, disconnect the plug from the mains
socket and wait for the device to cool down. CAUTION: The unit heats up to high temperatures during operation and may cause burns.
Do not touch the working part and nozzles during operation. After heating up, only hold the handle. Do not immerse the heat gun in
water or other liquids to cool down. Do not point the hot airflow at live parts, animals or people. Never clog or restrict the air inlet/
outlet openings of the device.
After the work is finished, it is advisable to turn the temperature control disc into position „1”, where the temperature is 60˚C, to cool
the device for 5~10s. Then set the switch to „0” and disconnect the plug from the electrical socket. Then place the heat gun in a vertical
position, placing it on a base built into the rear of the body and the handle and leave it to cool down. You can then proceed to cleaning
and maintenance.
MAINTENANCE, SERVICE, CLEANING
Always unplug the device from the mains socket before performing maintenance and cleaning. Use a dry, soft cloth or brush to remove
the dirt. Do not use cleaning agents or solvents. An air stream of not more than 0,3 MPa may also be used.
WASTE DISPOSAL
Damaged equipment, accessories and packaging materials should be recycled and used in an environmentally friendly manner.
