FIXING INSTRUCTIONS
INSTALLATION
GENERAL INFORMATION
•
Do not wire this lantern into the lighting circuit, use a switched fuse spur.
•
This fitting must be earthed, contact a qualified electrician to install a suitable earth facility.
•
Ensure the electricity is turned off at the mains before installing or maintaining any electrical fitting.
•
Please note: For new installations, check for any electrical cables or pipe work (gas/water) in the vicinity of the intended mounting point for
this product before proceeding with the installation.
Do not mount ceiling/wall fittings onto damp sufaces such as newly painted or plastered areas as this may cause discolouration of the finish.
Tools which may be required:
• Drill
•
Cross head screwdriver
•
Small electrical slotted screw driver
•
Insulation tape
1.
Fasten the adjustable bracket with stainless steel screws
2.
Connect the main line to the power wire of the lamp
3.
Note: Before installation. Only use a round cable supplied to connect this fitting (6mm diameter minimum. This is required in order to create a
good water seal when connected to the fitting.
4.
Ensure the terminal connection is made inside a suitable IP65 rated junction box (not included)
5.
Connect the main line to the power wire of the lamp.
1.
4.
2.
5.
3.
This product should be disposed of responsibly at the end of its life. Please recycle where facilities exist. Check with your local authority or retailer for recycling advise.
(Waste Electrical and Electronic Equipment Directive)
EN
