35
Instruction Manual
MORSØ Notch Cutting Machine
Model NXLEH
Working Procedure
The machine is switched on by starting switch - green (1) (the lamp (2) has a light).
Wait approx. 1 second (building up of the hydraulic pressure).
Place the work piece on the machine table and push it up to the adjusted stop.
With the switch (3) the required length of stroke of the knife block (4) is adjusted:
Position 1 = shortest length of stroke
Position 2 = full length of stroke
Switch (5) is the setup switch:
Position 0 = the knife block goes into top position
Position 1 = the knife block stays in bottom position
Switch (6) activates the clamping cylinders (7) + (8):
Position OFF = Clamping cylinders disconnected.
Position ON = Clamping cylinders connected.
Activate both pushbutton switches (9) + (10) simultaneously and the cutting cycle starts.
After finished cutting the clamping cylinders are automatically released.
The machine is switched off by switch - red (11) (the lamp (2) is turned off)
Post Working Procedure – Cleaning
Remove the wire from the wall socket. The machine is checked and cleaned thoroughly.
Remove any waste wood from the guidings and from behind the machine.
Keep the build-in hydraulic system free from waste and cover. This might cause over-heating
in the electric motor.
Resin from the mouldings can sometimes cause the knife blades to drag on the upward
action of the knife block. To remove this resin, use WD 40, sprayed onto a cloth made in the
shape of a ball (so that your fingers never go near the knives). Wipe in a downward action
only so that neither the cloth nor your fingers can come into contact with the cutting
edge of the knives.
Operating Instructions
F-8
