![Hoffmann MORSO NXLEH Operating Manual Download Page 27](http://html.mh-extra.com/html/hoffmann/morso-nxleh/morso-nxleh_operating-manual_2144170027.webp)
27
Instruction Manual
MORSØ Notch Cutting Machine
Model NXLEH
Adjustment of the Sensor in the Cock-bead Stops
The sensor (2) causes that the machine automatically does two cuts. If this is not the case
the sensor (2) is either wrongly adjusted or broke.
The sensor (2) is adjusted in the following way:
1. Start the machine. The knife block must be in setup position (bottom position).
2. Loosen screw (3) and press the wire for the sensor (2) 1 – 1.5 mm inwards. With a light
pressure on the axle (4) for the sensor with a finger the sensor gives a red light
immediately. When the pressure is removed, the sensor (2) must stop giving the red light.
Fasten screw (3) again.
3. If the sensor (2) does not react as described under paragraph 2, the procedure is repeated
until the correct reaction of the sensor (2) is achieved.
Operating Instructions
F-4-1