HOBO MicroRX Station Manual
1-800-LOGGERS 8
www.onsetcomp.com
Setting up the Station
Follow these steps to set up the station.
Tools required:
•
A Phillips-head screwdriver for installing the water level
sensor (RX2103 and RX2104 models) or mounting the
station to a flat surface with screws.
•
A ½ inch box wrench if using U-bolts to mount the
station to a tripod or mast.
•
Other tools may be required depending on the
accessories you are using for your station deployment.
1.
Log in to HOBOlink.
Go to www.hobolink.com and log in to an existing account
or create a new one. You’ll receive an email to activate the
new account.
2.
Register the station.
In HOBOlink, click Devices, then RX Devices, and click the
Register a Device link. Give the station a name and enter
the serial number and device key from the label inside the
station door.
Note:
If you are using your own micro SIM card, follow the
instructions at https://www.onsetcomp.com/support/
manuals/23845-installing-micro-sim-rx2100-station before
continuing.
3.
Mount the station.
There are three ways to mount the station using the built-
in mounting tabs.
Note:
You can also defer mounting until
the end of the process if you want to perform initial
testing.
•
Use the two sets of outer holes and 1-5/8 inch saddle-
clamp U-bolts to attach the logger to a tripod or mast
(this is the recommended method for mounting on a
mast). Do not use U-bolts without the saddle clamps as
that could bend the mounting tabs and damage the
housing or compromise the weatherproof seal. The flat
portion of the saddle clamps should be against the
mounting tabs.
•
Use the included cable ties with the two sets of inner
holes to affix the logger to a PVC pipe or mast.
•
Use the included screws and washers with the two sets
of outer holes to adhere the logger to a wall or flat
surface.
Important:
See
Deployment Guidelines
and
Installing the
Grounding Wire
for installation steps and other deployment
guidelines.
4.
Remove the cable channel.
Make a note of how the cable
channel is oriented when removing it.
5.
Install the water level sensor if applicable (RX2103
and RX2104 models).
a.
Insert the water level sensor cable jack into the water
level sensor. Screw on locking nut (hand tight).
Important:
Make sure the O-rings on the cable jack end and
the cable and sensor mating housing surfaces are clear of
any debris. Any contamination of these surfaces can cause
leaks that may lead to sensor failure.
b.
Plug the other end of the water level sensor cable into
the port on the right side of the board.
Cable channel
Inner mounting holes; use with cable ties
Outer mounting
holes; use with
screws and washers
or saddle-clamp
U-bolts
Inner mounting holes; use with cable ties
Plug in
water level
sensor
cable here
