5
Step 2
6
Step 3
Installation of Batteries into the Transmitter
Landing Gear Attachment
1. Remove the battery cover and install
the included 8 AA batteries.
2. Be certain that you observe proper
polarity when installing the
batteries, and then replace the
cover on the transmitter.
3. To test the transmitter’s function,
turn on the switch on the front of the
transmitter. The LED should glow
brightly.
4. Replace the batteries with fresh AA
batteries when you hear the low
voltage battery alarm beeping.
5. Once the alarm goes off, you only
have a few minutes of power left,
so don’t delay landing your plane
any longer than necessary to land it
safely.
1. Locate the included wire landing
gear.
2. Slide the landing gear into the
allotted slot on the bottom of the
fuselage.
3. Make sure the gear is securely in the
slot by gently pulling on it after it is
attached.
4. Attach the white plastic scale covers
with the included four (4) screws as
shown. They are located in the small
bag labeled “A.”
