![Hobbytech EP X2 Buggy Instruction Manual Download Page 36](http://html.mh-extra.com/html/hobbytech/ep-x2-buggy/ep-x2-buggy_instruction-manual_2142855036.webp)
ENGLISH
fra
N
ç
a
IS
DEUTSCH
ES
p
a
Ñ
o
L
36
even if this car is a ready to run kit, you still have some little things to do to familiari ze with your
product.
please follow these steps.
Steering Wheel : Control direction (Left / Right) of the
RC model
Throttle Trigger : Control speed and direction (Forward/
Brake/Backward) of the driving model.
Antenna : Transmit signal to the model
Power ON / OFF : Power ON / OFF the transmitter
SYNC & Battery Indicator : Top Green LED light indicates
synchronization status and/or
adequate battery power supply.
Power Indicator : LED light indicates power “ON”.
ATV : Adjustable Steering Rate by ATV dial
ST. Trim Dial : Adjust the neutral position of steering
servo when model wheels are straight
ahead.
TH. Trim Dial : Make sure the model stays still when
releasing the throttle trigger.
Battery Compartment Tray : Cover and hold the batteries powering
the transmitter.
kT2S TRANSMITTeR fUNCTIONS
pRe-RUN CheCk
Battery
Compartment Tray
Steering
Trim Dial
Steering
Wheel
Throttle
Trigger
Throttle
Trim Dial
Bind /
Setup Key
Antenna
Power
Indicator
ATV
Power
ON / OFF
Throttle
Reverse Switch
Steering
Reverse Switch
ReCeIveR ANd SeRvO CONNeCTION
ESC
Receiver
CH1
Steering Servo
Power Switch
Connect to
battery
Connect to motor
* Always turn on the transmitter first by sliding the switch on
the left side from bottom to top. The green lights above the
switch should light up. If not, you need to check for low or
incorrectly installed batteries.
1. Steering : Adjust the steering
trim to keep the front wheels
in straight line when steering
wheel remains in NEUTRAL
position.
2. Throttle : Adjust the throttle
trim to ensure the wheels stop
rotating when throttle trigger
remains in NEUTRAL position.
LED
indicator
LED
indicateur
bATTeRy INSTALLATION
Supplied with 4 x 1.5V AA Batteries,
KT2S can be operated a few hours.
Installation:
❶
Remove the battery
compartment cover as shown
below.
❷
Install the batteries
observing the polarity
marked on battery
compartment.
❸
Then reinstall the battery
compartment cover as the
Picture shown below.
CAUTION :
Do not dispose of batteries in fire,
short their terminals, apply heat to
them or disassemble them. .
Used batteries: Please dispose of
used batteries properly, following
any local regulations.
Battery distributors are required by
law to take back spent batteries;
they must not be thrown away as
household waste.
CH2
Summary of Contents for EP X2 Buggy
Page 48: ...NOTES 48 ...
Page 49: ...49 ...