Accessory list for the coming installation steps.
Accessory list for the coming installation steps.
1
Main wing joiner (16x534mm)
2
Washer (4x8mm)
2
Screw (4x35mm)
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
The standard sketch map when the kit install completion.
A = A '
B = B '
Assemble the wing to the fuselage and insert the other side
main wing to the fuselage via main wing joiner as illustration.
Insert the main wing joiner to one side of the main wing.
1
Main wing joiner (16x534mm)
Main wing joiner (16x534mm)
2
Washer (4x8mm)
2
Screw (4x35mm)
Fix the wing to fuselage with screws throught the holes
applied in the wings and fuselage.
1
1
Rod (2x300mm)
6
Collar (2mm)
1
1
Nut (2mm )
Screw (2x16mm)
1
1
Clevis
4
TP Screw (2.3x12mm)
Control horn
Screw
Spring Washer
Pin hinge(24x24mm)
A
A ’
B '
B
8
9
4
7
6
Set Screw (3x4mm)
Set Screw (2mm)
Rod (2x200mm)
Set Screw (2mm)
Washer (2mm)
Linkage Stopper
1
1
1
1
1
4
4
Washer (4x8mm)
4
Rod (2x300mm)
Blind Nut (5mm)
Screw (4x25mm)
Set Screw (3x4mm)
Assemble the throttle linkage.
Linkage Stopper
Washer (2mm)
Washer (2mm)
Nut (2mm)
Set screw (3x4mm)
Washer (2mm)
Set screw (3x4mm)
1
1
1
1
Install the servo of the throttle.
Washer (4x8mm)
Washer (4x8mm)
Screw (4x35mm)
Screw (4x20mm)
Nut (4mm)
Spring Washer (4mm)
4mm
Washer (4x8mm)
Assemble the engine.
The sketch map when the engine install completion.
Fuel supply line
Fuel spray line
Air pressure line
Assembly of the fuel tank.
Fix the fuel tank to appropriate position in the fuselage
with cable tie.
cable tie
2
cable tie
cable tie
33
34
37
35
9
36
32
