4
(with 5 servos),
4
4
4 channel radio for aiplane is highly recommended for this model.
Warning
Remove the covering with proper
pressure to cut through only the covering itself.Otherwise,
cutting down into the balsa structure may weaken the
model part and cause accident.
The pre-covered film on ARF kits may wrinkle due to
variations of temperature.Smooth out as explained right.
Li-Pox4 (2200mAh)
Pre-cover the covering with clean cloth!
Start at low setting. Increase the setting if
necessary.If it is too high,you may damage
the film.
Iow setting
with cover(cloth)
Motor controller:60A
Motor (KV): 600rpm/v
Engine dimension: 42x50mm
Apply epoxy glue.
4-cycle 52-70.
We strongly recommend you use the thread lock for all the screws when you build your model.
14
"
x7
2 in Spinner
The side view when the install completion.
105mm
105mm
Centre of the Gravity.
Top view
Position for
right diagram.
ELEVATOR
50mm
50mm
Adjustment of the elevator,be sure it can work perfectly.
80mm
80mm
Top view
RUDDER
Side View
Adjustment of the rudder, be sure it can work perfectly.
58
56
55
13
57
