Hobby King Turnigy 10XC, User Manual

Page: 16 / 27

To change the charger’s input supply current (amps) limit (Power Management feature):
a. Press and hold the MODE button , then release it when the display changes to this:
CHOOSE SPLY AMPS
Hold for More
Note: If you hold the MODE button down longer, you’ll see
LOW SUPPLY VOLTS
,
etc (described
below).
When you release the MODE button , you’ll see the current supply amps limit setting:
CHOOSE SPLY AMPS
Limit @ [current amps setting]
b.
Press and release the MODE button
until you see the current limit setting you want. Choices
range from 1A to 25A in 1A increments.
Note:
to protect your power supply from overload, make this setting approximately 10% lower than the
max current rating of your input supply. Factory Default for this setting is 25A. But realize that reducing
the supply current limit below 25A will extend charge times.
To change the charger’s input supply low voltage limit (Power Management feature):
a. Press and hold the MODE button , then release it when the display changes to this:
LOW SUPPLY VOLTS
Hold for More
Note: If you hold the MODE button down longer, you’ll see
NODE CONNECTOR?
, etc (described
below).
When you release the MODE button , you’ll see the input supply current low voltage limit
setting:
LOW SUPPLY VOLTS
Limit @ [volts]
b. Press and release the MODE button until you see the input supply low voltage limit setting
you want. Choices range from 10V to 28V in 0.1V increments.
Note:
Press the button about once per second to select 0.1V increments. Press the button faster to scroll
in 1V increments. 10V is the Factory Default setting and is the lowest input voltage for safe operation of
the 10XC; however, you may choose to raise this voltage to protect your input supply. For example, you
should avoid operating at lower than 11 or 11.5V using a 12V Pb battery as input as over-discharge will
severely shorten the life of the input battery.
To toggle the charger between DEFAULT and XH balance connector wiring:
a. Press and hold the MODE button , then release it when the display changes to this:
NODE CONNECTOR?
Hold for More
Note: If you hold the MODE button down longer, you’ll see
Quiet Charging
, etc (described
below).
When you
release the MODE button
, you’ll see the currently selected balance connector wiring
January 17, 2012 ver 1.0 www.revolectrix.com
16