Step 26: Upper Frames 26mm Cross-member
Parts List
3 X 8mm Cap Head Bolts (4)
26mm Cross-Member (2)
Install the 2-26mm Cross-Members Into the
Upper Frames with 3 X 8 mm Cap Head Bolts
Step 27: Radio Setup
First, change your radio to 3 Point, 120 Degrees
swashplate mixing. My advice is to read your radio manual for proper
adjustment of the swash mixing.
After you have the radio gear installed, the basic guide-lines for proper
setup of an EMS system is everything must be 90 Degrees and Parallel
with all control sticks in the center. After all linkages are installed and
everything meets the above requierments, you should have 0 degrees of
main rotor blade pitch at center stick. Make the necessary adjustment
to complete the setup.
Pitch Curve Setup:
Complete the following steps in the Pitch Curve Menu of the Radio. In
Normal Mode make the Pitch curve the following: at Bottom-Stick,
0 to -2 Degrees; Mid-Stick, 5 to 6 Degrees, and Top-Stick, 9 to 10 Degrees.
For Stunt 1 & 2: Bottom-Stick, -9 Degrees; Mid-Stick, 0 Degrees; and
Top-Stick, 9 Degrees. Note: Stunt one and two should only be used by
pilots ready for forward flight and aerobatics. Do not use these settings
until your skill level is ready.
Throttle Curve Setup: Normal Mode, Bottom-Stick 20 Percent throttle;
Mid-Stick, 50 Percent Throttle, Top Stick 100 Percent Throttle. Stunt
1 & 2 Bottom-Stick 100 Percent; Mid-Stick, 25 Percent; Top Stick, 100
Percent.
Tail Rotor: Setup the Tail rotor limits so the throws that the tail pitch
slider does not exceed a 5mm gap between the tail case and the tail pitch
slider.
