![background image](http://html.mh-extra.com/html/hobbico/skyvista/skyvista_assembly-instructions-manual_2142405004.webp)
4
Install the rubber grommets with brass
inserts to each of the four servos.
N
No
otte
e:: Your system may look slightly
different. Consult your radio instructions.
C
C.. Turn off your receiver switch followed by
the transmitter. Your servos are now
properly centered.
N
No
otte
e:: If you bump or move your servos
during assembly, simply repeat this step.
SECTION 1
SECTION 1
Radio System Preparation
STEP 1: Unpack your Radio System
STEP 2: Connect your Radio System
B
B.. Install the Brass Pushrod
Connectors onto
T
TW
WO
O
of the arms.
C
C.. Squeeze the nylon retainers in place
using your pliers.
A
A.. From your radio system, select four
arms that look like an “X” or Star and
snap off the sides with your pliers.
(A diagonal cutter works well also).
STEP 3: Choose the Control Arms
A
A.. Connect your radio
system and turn it on.
B
B.. Position the “trim levers”
and sticks as shown.
ON
Throttle
Receiver
Battery
Servos
Transmitter
Switch
(Off)
Receiver
Brass Connector
Brass Connector (2)
4-40 Screw
4-40 Screw (2)
Nylon Retainer
Nylon Retainer (2)
Actual Size
Elevator
Enlarge
Enlarge
Enlarge
Tip! Hold the drill
bit with a pliers and
turn the arm.
Aileron
Rudder
Throttle
“X” Horn
Remove the wheels.
Charge your radio system following the
manufacturer’s instructions. This is usually
an overnight process.
Your grommets
may install like
one of these.
Throttle Trim
Star Horn
or
D
D.. Enlarge the selected holes in the
servo arms using a #48 (5/64")
drill bit.