11
A
A.. Insert the steering pushrod wire through the outer hole in
the nylon steering arm. Slide the wire into the tube so
that it will extend through the brass connector on the
rudder servo.
B
B.. Place a 4mm metal collar over the nose gear strut. Slide
the strut in place capturing the steering arm between the
bottom bracket and engine mount.
C
C.. Tighten the steering arm screw so the end of the steering
arm is positioned about 3/8" (10mm) from the firewall while
the nose gear is straight.
D
D.. From the inside of the fuselage, tighten the screw to secure
the pushrod to the brass connector.
STEP 1: Install the Steering Hardware
Landing Gear Installation
Part
Part
Three
Three
A
A.. Insert the two main landing
gear wires into the slots on the
bottom of the wing
B
B.. Secure the landing gear using
four metal straps and eight
2.5 x 10mm screws.
C
C.. Attach the wheels using the
4mm metal collars with the
3 x 5mm screws.
D
D.. Attach the remaining wheel to
the nose gear strut.
STEP 2: Install the Main Landing Gear and Wheels
4mm Metal Collar (1)
4mm Metal Collar (6)
3 x 5mm Screw (1)
3 x 5mm Screw (6)
2.5 x 10mm Screw (8)
Metal Strap (4)
3 x 8mm Screw (1)
3 x 8mm Screw
Nylon Steering
Arm
IMPORTANT! Check and
retighten the engine
mount screws.
Note: Fuel tubes
omitted for clarity.
Metal Collar
2.5 x 10mm Screw
3 x 5mm
Screw
Pushrod
Tube
Nose Gear
Strut
3 x 5mm Screw
Pushrod
Use drill bit to
enlarge the
outside hole.
Actual Size
Actual Size
Actual Size