❏
2. This is a good time to make sure that your radio’s servo
reversing switches are correctly set. If you are using the
transmitter included with the Park Pilot, the reversing switches
are located on the lower right front of the transmitter. The Ch1
switch should be set to Rev, Ch2 set to Rev and the Mix switch
set to off. If you are using a radio system not included with the
Park Pilot, the servo reversing will be covered during the servo
adjustment.
❏
3. Install the transmitter antenna in the transmitter by
threading it into the top of the transmitter. If you are using a radio
system not included with your Park Pilot, follow the radio
manufacturer’s instructions on installing the transmitter
antenna.
❏
4. Remove the battery cover from the bottom of the fuse.
Make sure the switch on the side of the plane is off. Plug the
battery to the speed control and fit the battery in place with the
battery cover.
❏
5. Switch on the transmitter then the airplane. Center the
rudder and elevator trim levers.
❏
6. With the rudder and elevator sticks and trims centered, the
rudder must be straight, in-line with the fin and the elevator,
9
