- 6 -
Elevator
Ailerons
+/- 5mm
+/- 7mm
In the following picture you can see a possible placement
of the compnents like receiver and battery. To have no
problem with the CG, you should place the receiver as
backmost as possible.
For connecting the ailerons you can use the included
V-cable.
If you like experimenting with flaps or you like aileron
differentiation, it would be better to connect each aileron
servo to a separate channel.
5cm
The CG is located 5cm behind the joint of fuselage and
main wing. Especially small models require a correct CG
to have good flight performance.
FLWA4131
Motor cowl T28-Mini
FLWA4132
Fuselage upper part with canopy
FLWA4133
Speed spinner
FLWA4134
Brushless motor T28-Mini
FLWA4135
ESC T28-Mini
FLWA4136
Servo T28-Mini
FLWA4137
Prop adapter incl. screws T28-Mini
HCAQ9008
Tuning propeller APC 5 x 5 E
If you prefer more scale look, you can replace the speed
spinner with the provided scale spinner.
During the last few moments of preparation
your mind may be elsewhere anticipating the
excitement of the first flight. Because of this,
you may be more likely to overlook certain
checks and procedures that should be per-
formed before the model is flown. To help
avoid this, a checklist is rovided to make
sure these important areas are no over-
looked. Many are covered in the instruction
manual, so where appropriate, refer to the
manual for complete instructions. Be sure to
check the items off as they are completed
(that's why it's called a check list!).
