- 5 -
Remove the color from the glueing areas by sanding the
parts carefully. For hidden areas you can use a glass
pencil, which you can get from the stationery store.
If you put the parts together with 5 min. epoxy glue, take
care for a correct alignment. Fix the parts with pins until
the glue is setted.
Attention!!
Never take CA glue for EPO, because this glue causes
damages to this material. Always take epoxy glue.
If you use to much of epoxy glue, the glue is oozing out
between the parts. You can remove this glue, using a
cotton stick.
Before you glue the tail unit to the body, it is very important, to hook in the elevator linkage. Use the third hole, away
from the flap.
Afterward you can glue the complete unit to the fuselage, looking for correct aligment. Take care, that the lower part of
the rudder meets the fuselage at the center. Put also epoxy glue there. Fix the unit with pins until glue has hardened.
Adjust the elevator linkage so, that elevator flap and servo
lever are in neutral position as shown in the picture. The
position of the clevis should be the third hole from oter
side of the servo lever.
Take care, that the prong of the clevis snaps correct to the
opposite side.
Additional you can fix the clevis with a small shrinking
tube, provided in this kit.
