To measure the length of bulk cable
1.
Peel
off the cable jacket of the Green/ Green white wires.
2.
Use the attached cable in the package. (RJ45 plug to two alligator clip)
3.
Plug one end of RJ45 to the Main unit
and the other end to the two
alligator clips,
Green clips to the Green wire and White clips to the Green white wire.
4.
Test the cable length.
Tone Generator
At 1 KHz frequency, the LANsmart Pro emits an audio signal to a cable; user can
trace the cable with corresponding cable tracer.
Select the Analog Tone options from Identification menu
Cable Test
Length Test
Identification
Configuration
Analog Tone
Digital Tone
Port Finder
ENTER
User can select the pins to
send the tone
signal.
The Selected pin will be highlighted.
Select to stop Tone mode and return to previous
menu.
Note: Under normal conditions Tone on all pins will
be louder than Tone on single pin.
Select the Digital Tone options from Identification menu
Select Single tone or Double Tone from Digital Tone.
Press ENTER to
send
Digital Tone
Port Finder
Port finder is a distinctive feature. Professionals recommend it. It is used to identify
correct ports the cable is using. The correspondent port’s LINK LED will blink, once
the LANsmart Pro sends 10M fast link signals through the cable. Cable labeling has
just become so much easier.
PIN 1 2 3 4
5 6 7 8
All Pins
Double Tone
Sending …
Single Tone
Sending …
ENTER
Cable Test
Length Test
Identification
Configuration
Analog Tone
Digital Tone
Port Finder
ENTER
LANsmart Pro sends fast link signals until is selected.
Single Sending . . .
10
