Specifications:
Input
- IDC50 male, IDC40 male, IDC34 male, IDC26 male,
IDC10 male, DB15 male & DB9 female.
Output
- IDC50 male, IDC40 male, IDC34male, IDC16 male,
IDC10 male, DB25 male & DB25 female.
•
Control Switches - Read, Test, Up & Down
•
Display
- Liquid crystal display with backlight
•
Extension ports - 2x40 pins IDC male connectors
•
Power
- 9V DC Battery or 110/220V to 9V DC 150mA, 2.50 power
jack
•
Size
- 250Lx134Wx35H(mm), (9.9” x 5.3” x 1.38” )
•
Weight
- 8OOgr (1.761bs
Operation:
Read a cable
1.
Slide the power switch on. The tester will automatically operate the self-test
and LCD display will show “LCD BACKLIGHT ON/OFF CONTROL”
2.
If you are going to enable the LCD BACKLIGHT, push any switch once
except READ switch. If you are going to disable LCD BACKLIGHT, push
the READ switch once. Then the LCD display will comes to “Ribbon-666 *
Cable Tester*”
3.
Connect one end of tested cable on the corresponding connector of the left
side test interface and another end to the right side.
4.
Press the READ switch once, the LCD display will show “**Reading...**”
then shows “---END---” after the tester completes the read.
5.
If you want to read the pin configuration out, you may press UP or DOWN
switch to read it out.
