19. Remove balance piston o-ring and balance
piston spring.
20. Remove meter drive pawl.
21. Remove meter disc.
22. Install correct meter disc and reassemble in
reverse order.
NOTE:
Make certain all components are correctly
installed.
NOTE:
Be certain to start cap screws by hand
rotating backwards until screw drops into thread then
tighten. An alternating, crossing pattern should be
used while tightening cap screws to ensure correct
cap fit.
23. Remove brine valve assembly from cabinet to
set float cup.
24. To remove brine valve assembly, remove tubing
from softener cabinet.
25. Disconnect tubing from brine valve elbow by
holding the collet and pulling tubing straight
away.
F25407 (February 2011)
Page 5 of 16
