Hobart CHH50, Use And Maintenance Manual

Page: 6 / 35

USE AND MAINTENANCE MANUAL
A
2.4 DRAIN CONNECTION
Gravity for all models, except EH70, so the drain needs to be
situated below the base of the machine. Model EH70 requires a stand-pipe
The drain pipe needs to be connected to a drain- trap built
into the floor.
The drain dimensions are shown in the installation drawing.
2.5 ADJUSTMENTS AND CHECKS
The temperature of the wash tank is regulated by a fixed thermostat at
about 55° C. This temperature ensures proper action by the chemicals
contained in industrial dishwashing detergents.
The boiler temperature set by a fixed thermostat is about 85° C.
2.6 RINSE-AID DISPENSER
Before adjusting, the dispenser and hose need to be filled
using the primer button (
A ).
To adjust use the ring nut ( B ) situated at the center of the
dispenser, rotating clockwise reduces the quantity,
counterclockwise increases it.
The dispenser must not operate empty
An excessive amount of rinse agent causes bluish stripes on the
dishes and creates foam in the wash tank.
Specification
French degrees
German degrees
English degrees
Parts per million
Maximum
Hardness
Residual
Minerals
f
°dH
°e
ppm
mg/l
From
5
4
5
70
To
10
7’5
9,5
140
300/400
B
page 5