INSTALLATION
Page 1
1
Adjust the detergent potentiometer on the electronic control card (consult layout diagram), turning it
fully counter-clockwise to obtain zero detergent dosage.
Start a wash cycle, with no dishes in the machine, and allow the chamber to fill with water.
On completion of the filling cycle and before the wash cycle has
started, open the door and pour the previously determined quantity of
detergent into the chamber in the region of the wash pump suction
filter.
About 10 seconds after the start of the wash cycle, start turning the
potentiometer in a clockwise direction until you hear a buzzing which
indicates that the dispenser is delivering detergent to the chamber. At
this point the dispenser is calibrated to the previously determined
dosage.
Any subsequent adjustment to the dosage should be made on the basis of the results obtained after a
number of real wash cycles (turn the potentiometer clockwise to increase the dosage and
counter-clockwise to decrease it.).
6.
Operator training
The installer is required to provide the users with suitable instruction on the operation of
the appliance and on the safety precautions. He/she must also give practical demonstrations of
the use of the appliance and ensure that he/she is in possession of all the documentation supplied
with the appliance.
Note that to obtain the best performance and longest service life from the appliance, it must be used
in accordance with the operating instructions, which must be kept in a safe place, with
particular attention to maintenance (routine, periodic and major) and to periodic sanitation using
non-corrosive commercial products.
EF 40
Summary of Contents for CHF 45
Page 1: ......