OM-194 034 Page 13
$ 6'
? $
:
Replace
unreadable
labels.
Repair or
replace
cracked
weld cable.
Clean and
tighten weld
terminals.
% :
Blow out or
vacuum inside.
During heavy
service, clean
monthly.
Or
$ (* &) 6 +'
1 Bearing
2 Feed Roll Plate
3Drive Roll
The drive roll consists of two differ-
ent sized grooves. The stamped
markings on the end surface of the
driverollreferstothegrooveonthe
opposite side of the drive roll. The
groove closest to themotor shaftis
the proper groove to thread (see
Section 3-8). NOTE: when chang-
ing drive rolls, make sure the
woodruff key is on the motor shaft,
and not in the old drive roll.
4 Pressure Arm
Tools Needed:
1
2
4
3
.030 Groove
.024 Groove
Stamped .024
Stamped .030
