Hobart Welding Products Hobart 300/300, Owner'S Manual

Page: 18 / 76

OM-494 Page 14
SECTION 4 – NSTALLATION
When facing the front panel, the Welder B controls and weld terminals are on the
right and the Welder A controls and weld terminals are on the left.
NOTE
4-1. Installing Welding Generator
install1 10/00* – Ref. 800 652 / Ref. 800 477-A / 158 936-A / S-0854
1
2
Electrically bond generator frame to
vehicle frame by metal-to-metal
contact.
GND/PE
3
4
Always ground generator
frame to vehicle frame to pre-
vent electric shock and static
electricity hazards.
Always securely fasten
welding generator onto
transport vehicle or trailer
and comply with all DOT and
other applicable codes.
1 Generator Base
2 Metal Vehicle Frame
3 Equipment Grounding
Terminal
4 Grounding Cable
Use #10 AWG or larger insulated
copper wire.
Be sure equipment con-
nected to the 240 V recep-
tacles is GFCI-protected.
2
OR
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
OR
Movement Airflow Clearance Location
Grounding
OR
Do Not Lift Unit From End